CF812 HILTI Door and Window Minimum Expanding Foam Sealant-12 Cans 227975Foam Yield (up to): 1.3 ft�, Chemical basis: Polyurethane, Approx. cut time (at 23�C / 50% rel. Humidity): 15 ...
It's easy to form durable, airtight, water-resistant bonds to vinyl, wood and metal frames. This one-component, minimal-expanding, low pressure-build, flexible polyurethane foam is exclusively formulated to air seal the gap between a window or door frame and its rough opening. The foam expands only enough to generate an effective seal. When applied properly, Dow GREAT STUFF PRO Window & Door 187273 is proven not to distort or bow window and door frames. GREAT STUFF PRO Window & Door Insulating Foam Sealant is designed to form a durable, airtight, water-resistant bond to vinyl, wood and metal surfaces. Its foam skin repels and deflects water, which can help reduce the potential for moisture damage in frame openings. The straw foam Great stuff loses between 10 to 15% of its Yield through the straw, whereas the Pro Gun draws every bit of foam from the can and is much quicker on the job. Time and Yield are essential ingredients for profit. GREAT STUFF PRO Window & Door Insulating Foam Sealant is available in gun- and straw-applied versions. This listing is for the gun-applied version. Application GREAT STUFF PRO Window & Door should be applied at temperatures between 40°F and 100°F (4°C and 38°C) at relative humidity > 20 percent. Surface where applied should be free of dust, grease, oil, wax and release agents. Damp surfaces will not impair the bond.
Strong Nylon Strap Supports Both LitesRubber Coated Steel "Foot" Prevents ShearLifting insulating glass units with vacuum cups on only one side of the unit means that the lite of glass on the other side is supported solely by the edge sealant used to produce the unit. To reduce the amount of shear force while lifting in this manner, simply employ a pair of CRL Wood's Insulating Glass Anti-Shear Supports. When used with vacuum lifting frames, attach a pair of the supports to the bottom of the unit for vertical lifts. If rotating the unit, attached at 90 degrees as shown in the diagram above for support in both directions.CRL Wood's Insulating Glass Shear Supports can also be used when lifting I.G. units by hand to provide the same safety as when used with vacuum lifting frames. Just thread the straps of each of the supports together so the insulating glass unit is held together, top and bottom as shown in the diagram above. Attach two or more vacuum cups to the front light. The unit can then be lifted securely.